TRACING PLUS - HIGH PERFORMANCE LINE MARKER [12 Months]
Being particularly dirt-resistant, it is ideal for marking lines in high-traf c areas such as factory oors and logistics warehouses.
With its 750 ml packaging, TRACING® PLUS offers durable and economical marking, notably indoors.
NSF certified to comply with use in food processing facilities.
PROPERTIES
• Excellent adhesion and high resistance to mechanical wear.
• Excellent resistance to dirt.
• Crisp, sharp lines thanks to its purpose- designed nozzle.
• Rapid drying: approximately 15 to 20 min.
• Marking duration: approximately 12 months, depending on the application surface, usage and wear.
• Application temperature: from +5°C to 50°C.
• NSF “non-food compound” certi ed, usable in food storage areas or where food products are manufactured. NSF is the most know organism over the World. Registration number 149 448. Catregory code P1.
SPECIFICATIONS
Composition
Binder: acrylic and alkyd urethane blend
Pigments: mineral and organic, free from lead
and cadmium
Solvents: a complex blend free from chlorinated
solvents and aromatic compounds (toluene,
xylene, etc)
Propellant: dimethyl ether
Application method
Manually or using our application equipment (4-wheels marking trolley, hand gun, see page 15) Drying Time: 15 to 20 min
Health and safety
Safety data sheets are available free of charge on
the internet: www.quick-fds.com
CLP labelling with a single pictograph
GENERAL CONDITIONS FOR USE
Whatever the nature of the surface, the following
conditions are essential for the optimal application
of
TRACING® PLUS:
Correct preparation of the surface to be painted is imperative to obtain excellent paint adhesion. Thoroughly clean the surface to ensure that it is free from dust, dirt, grease, etc.
Relative humidity should be between 10% and
50%.
The application temperature should not be below
5°C.
For a good quality line, the rst coat should be ap- plied quickly (print layer); on the other hand the second and optional third coats should be applied more slowly to obtain the desired coverage.
Recommendations by surface type:
• CONCRETE
Before applying TRACING PLUS® to a new
concrete surface, allow a minimum of 3 to 4 weeks
for complete drying (French building trades stan-
dards) and the elimination of acidity.
• ASPHALT
It is advisable to wait at least 15 days before
line-marking a new asphalt surface in order to
avoid any alteration to the quality of the marking.
• Special conditions applicable to “synthetic” (plastic, PVC, varnishes) and painted (epoxy, PU) oor surfaces.
In this domain, there are several different types of paint and the paint used for the oor may be incompatible with TRACING® PLUS (resulting in poor adhesion). We therefore recommend carrying out a test beforehand for these speci c types of surface.
Lines can be given a protective coating of our PRO- TECT LINE varnish (see page 12) for improved lon- gevity and dirt-resistance.
RECOMMENDATIONS FOR USE
• Use head down, adjust the position of the aero- sol in the equipment used to give an application height that produces the desired line width.
• BEFORE USE: Shake the can vigorously in an upside down position to thoroughly mix the paint, continue shaking even after having clearly heard the ball bearings.
• AFTER USE: Purge head up (until gas only co- mes out) to clean the valve and nozzle.